MERCURY Enterprises We, “Mercury Enterprises”, are a supplying & trading an optimum range of Brakes & Clutches Combination. Our range consists of LM Ball Screw, Brake Motors, Machine Components.Due to the durability and optimum quality of our range. Due to our association with the reputable vendors of the market, we have been able to manufacture our range using top quality raw material.

Being a renowned organization, we are involved in offering a wide range of Pneumatic Clutch. These are one of the most favored selections of clients owing to its optimum strength, robust design and consistent performance. Demands of these devices are increasing day by day owing to its longer service life and optimum quality. These are admired for their purpose specific design and reliability. Models available are as follows: Model CW: Consisting of a pressure plate, hub and torque assembly, the model CW is designed for mounting on any suitable flat surface on either the drive or driven side of the power transmission system where the flat surface is large enough to accommodate the bolt circle of the pressure plate. The compact size of the CW permits installation in areas that might not be considered suitable for other type clutches. Model CR: Designed for installation in a power transmission system where available mounting surfaces of items to which the clutch is to be fastened (IE., sheave, sprocket, flywheel, gear) have a diameter smaller than the bolt circle of the pressure plate. The model CR has a pressure plate, hub, torque assembly and a registered backplate with a bolt pattern for a mounting surface. The finned pressure plate and backplate allow the model CR clutch greater heat dissipation capabilities. Model CK: Used in applications as a coupling clutch, the model CK features a compact design and an ability to provide high torque instantaneously or give soft star capabilities to high inertla loads. The model CK is equipped with a pressure plate, torque assembly, backplate, keyed hub and keyed backplate hub for coupling both shafts. Model PM (Pilot Mount): Power Flo pilot mount clutches are available in sizes from 8.5 to 25 inches in diameter. The model PM is a self-contained, bearing mounted clutch designed for mounting on the end of a shaft. This model consists of a finned pressure plate, torque assembly, adapter shaft that is bored to fit the customer's shaft and a bearing mounted pilot backplate for mounting a sheave, sprocket, gear, etc. Model IM (Integral Mount): Power Flo Integral mount clutches are available in sizes from 8.5 to 18 inches in diameter. The model IM is a self-contained, bearing mounted, integral sheave clutch designed for installation on the end of a shaft. The unit contains a finned pressure plate, torque assembly, adapter shaft bored to fit the customer's shaft and a bearing mounted integral sheave/backplate designed to the customer's specifications. On all Power Flo clutch models, the standard hubs and backplate hubs may be furnished witha bore and keyway to fit eisting shafts. Therefore specific bore and keyway must be specified. Standard tolerance on the bore is plus .001 minus .000 and keyways will be furnished in accordance to keyway standards unless otherwise specified. All equipment that Power Flo clutches are mounted on should be made so that misalignment between the two axis of rotation at the clutch is less than .0005" offset and less than .002"/inch angular.